Digital Monitoring Products XT50 Guida di Installazione Scaricare il pdf (Pagina 9)

Digital Monitoring Products XT Series Programming Guide

INTRODUCTION

1.3 Programming Menu

You are now ready to start programming the XT30/XT50 panel. Pressing the COMMAND key scrolls you

through the programming menu items listed below.

Menu Item Section in This Manual Menu Item Section in This Manual

Initialization 2 Bell Options 10

Communication 3 Output Options 11

Network Options 4 Output Information 12

Messaging Setup 5 Area Information 13

Device Setup 6 Zone Information 14

Remote Options 7

Stop

System Reports 8 Set Lockout Code 16

System Options 9 Appendix 17

To select a section for programming, press any Select key/area when the name of that section displays on

the keypad. The detailed instructions for each programming step are found in this manual.

1.4 Programmer Lockout Codes

Although the XT30/XT50 panels allow you to access Programmer mode without a lockout code, it is

recommended you program one to restrict programming access to authorized individuals only. You can do

this by using SET LOCKOUT CODE at the end of the programming menu.

Installing a lockout code

1. After entering the Programmer menu, the keypad displays PROGRAMMER. Press the COMMAND key

until SET LOCKOUT CODE is displayed (after STOP).

2. Press any Select key. At the ENTER CODE: - display, enter a 1- to 5-digit programmer lockout code.

Press COMMAND.

3. The displays shows ENTER AGAIN. Enter the same lockout code again and press COMMAND. The

display shows CODE CHANGED. The new code number must now be entered before the Programmer

menu can be accessed.

The lockout code should be written down and kept in a secure place with access limited to authorized

persons only.

Lost Lockout Code requires factory reset: If you lose or forget the lockout code, the panel must be sent

back to the factory to be reset. There is no eld option for gaining access to the panel without a valid

lockout code.

1.5 Reset Timeout

The XT30/XT50 has a feature that requires you to enter the Programmer within 30 minutes of resetting

the panel. After 30 minutes, if you attempt to program by entering the 6653 (PROG) code, the keypad

displays: RESET PANEL. You must reset the panel and enter the program code within the next 30 minutes.

If you are already in the Programmer and do not press any keys on the programming keypad for 30

minutes, the panel terminates programming. All data entered up to that point is saved in the panel’s

memory.

Using the STOP function disarms all areas: To exit the panel’s Programmer you must use the Stop

function. The STOP option is the second to the last option in programming. The Stop function disarms all

areas and clears the panel’s Status List.

The programming session is then terminated and the keypad returns to the Status List or Main Screen.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 54 55

Commenti su questo manuale

Nessun commento

Digital Monitoring Products XT50 Guida di Installazione Pagina 9

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Digital Monitoring Products XT50