Digital Monitoring Products XR20 Guida di Installazione Scaricare il pdf (Pagina 17)

XRSuper6/XR20/XR40 Programming Guide Digital Monitoring Products

CommuniCaTion

3.9

TEST TIME

00:00 AM PM

Test Time

Press COMMAND to enter the Test Time. Enter the time of day the panel sends the

test report to the SCS-1R Receiver. Use entries between 12:00 to 11:59 and then

choose AM or PM.

Automatic test messages are sent through the dialer unless NET is programmed as

Main Communication and no telephone numbers have been programmed. Then the

test message is sent through the network.

3.10

RECEIVER 1 PROG

Receiver 1 Programming

Allows you to set the options for the rst receiver the XRSuper6/XR20/XR40 panel

attempts to contact when sending reports. The XRSuper6/XR20/XR40 supports

communication to two receivers.

3.11

ALARM NO YES

Alarm Reports

YES enables Abort, Alarm, Alarm Restoral, Alarm Bell Silenced, Ambush, Exit Error,

and System Recently Armed reports to be sent to this receiver.

3.12

SPV/TRBL NO YES

Supervisory/Trouble Reports

YES enables Supervisory, Trouble, Trouble Restoral, Force Armed, Late to Close, and

Fault reports to be sent to the receiver.

3.13

O/C USER NO YES

Opening/Closing and User Reports

YES enables Opening/Closing, Door Access, Schedule and Code Changes, Bypass, and

Sensor Reset reports by user to be sent to this receiver.

3.14

TEST RPT NO YES

Test Report

Enter YES to enable the Recall Test report to be sent to this receiver.

3.15

BACKUP NO YES

Backup Reporting

YES enables this receiver to be a backup to the other receiver in the event the

other receiver cannot be contacted.

Note: When Backup Reporting is set to YES, the Cellular Backup Output programmed

in Output Options is automatically set to zero.

3.16

FIRST PHONE NO.

First Telephone Number

Enter the rst number the panel dials to send reports to this receiver. A phone

number may contain two lines of 16 characters to equal 32 characters. You can

program a three-second pause in the dial ing se quence by en tering P. Program a

dial tone detect by entering D. These characters are counted as part of the 32

characters.

Call Waiting: You can place the “* 7 0 P” (Star, Seven, Zero, Pause) in the telephone

number rst position to cancel Call Waiting. For example, program NET with second

line DD and phone number *70P555-1212, and you have NET with Call Waiting

cancelled on the second line.

Caution: A call waiting cancel programmed on a non-call waiting telephone

line would prevent communication to the central station.

3.17

SECOND PHONE NO.

Second Telephone Number

The panel dials the second number after two successive attempts failed using the

rst number. If the panel cannot reach the receiver after two attempts using the

second number, it returns to the rst number and makes two additional attempts. A

total of ten dialing attempts are made using the rst and second phone num bers. If

a second phone number is not entered, the rst phone number is used for all dialing

attempts. Each number can be up two lines of 16 characters to equal 32 characters

in length, in cluding any P, D, or *70P char acters entered for pause, dial tone detect,

or call waiting cancel option.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Commenti su questo manuale

Nessun commento

Digital Monitoring Products XR20 Guida di Installazione Pagina 17

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Digital Monitoring Products XR20