Digital Monitoring Products XR20 Guida di Installazione Scaricare il pdf (Pagina 12)

XRSuper6/XR20/XR40 Programming Guide

Digital Monitoring Products www.dmpnet.com 2500 N. Partnership Boulevard Springfield, MO 65803

3.1 COMMUNICATION

The Communication section allows you to configure the communication settings for

the XRSuper6/XR20/XR40 panel. After choosing the Communication Type, continue

through the list of options.

3.2 COMMUNICATION TYPE

This specifies the communication method the panel uses to contact the receiver.

Press any Select key to display the following communication options:

NONE - For local systems. Selecting this ends communication programming.

DD - Digital Dialer communication to DMP SCS-1 Receivers.

4-2 - 4-2 communication to non-DMP receivers.

M2E - Modem IIe communication to non-DMP receivers. This format sends the report

codes of the Radionics Modem IIe communication format.

CID - Contact ID communication to non-DMP receivers. This format sends the report

codes of the Ademco Contact ID communication format.

3.3 ACCOUNT NUMBER

Enter the account number sent to the receiver.

DD - The range of account numbers for Digital Dialer is 1 to 65535. For account

numbers of four digits or less, you do not have to enter leading zeros. The panel

automatically right justifies the account number.

4-2, M2E, and CID - The range of account numbers for these formats is 1 to 9999.

3.4 TRANSMIT DELAY

Enter the length of time the panel waits before sending burglary alarm reports to

the receiver. The available range is 10 to 60 seconds in ten-second increments.

Alarm bells and relay outputs are not delayed during this period. Burglary Outputs

must be programmed for Steady.

If the area where the alarm occurred is disarmed during the Transmit Delay, only an

Abort Report is sent. Abort Reports must be set to YES. Enter zero to disable

Transmit Delay.

3.5 DTMF

YES enables tone dialing. NO enables rotary dialing.

3.6 DEFER TEST TIME

Select YES to allow the programmed test report to be deferred if the panel

communicates with a receiver within the time set in Test Frequency. Select NO to

send the test report as programmed in Test Frequency regardless of previous panel

communication.

COMMUNICATION

XMIT DELAY: 0 0

DTMF YES

DFR TEST YES

COMM TYPE: NONE

COMMUNICATION

NONE DD 4-2 M2E

CID

ACCOUNT NO:12345

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Commenti su questo manuale

Nessun commento

Digital Monitoring Products XR20 Guida di Installazione Pagina 12

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Digital Monitoring Products XR20