Digital Monitoring Products XR20 Guida di Installazione Scaricare il pdf (Pagina 8)

XRSuper6/XR20/XR40 Programming Guide

Digital Monitoring Products www.dmpnet.com 2500 N. Partnership Boulevard Springfield, MO 65803

1.3 Programming Menu

You are now ready to start programming the XRSuper6/XR20/XR40 panel. Pressing the COMMAND key

scrolls you through the 10 programming menu items listed in below.

Note: The 692 Security Command keypad is not suitable for panel programming.

Menu Item Section in this manual

Initialization 2

Communication 3

Remote Options 4

System Reports 5

System Options 6

Output Options 7

Area Information 8

Zone Information 9

Stop 10

Set Lockout Code 11

To select a section for programming, press any one of the top row Select keys when the name of that

section is displayed on the keypad. The detailed instructions for each programming step are found in

sections 2 to 11 of this manual.

1.4 Programmer Lockout Codes

Although the XRSuper6/XR20/XR40 panel allows you to enter the built-in Programmer without a lockout

code, we recommend you install one to restrict programming access to only those persons your

company authorizes. You can do this by using SET LOCKOUT CODE at the end of the programming

menu.

Installing a lockout code

1. After entering the Programmer menu, the keypad displays PROGRAMMER. Press the COMMAND

key until SET LOCKOUT CODE is displayed (after STOP).

2. Press any top row Select key. At the ENTER CODE: - display, enter a 1- to 5-digit programmer

lockout code. Press COMMAND.

3. The displays shows ENTER AGAIN. Enter the same lockout code again and press COMMAND. The

display shows CODE CHANGED. The new code number must now be entered before the

Programmer menu can be accessed.

The lockout code number should be written down and kept in a secure place with access limited to

authorized persons only.

Lost Lockout Code requires factory reset: If you lose or forget the lockout code, the panel must be

sent back to the factory to be reset. There is no field option for gaining access to the panel without a

valid lockout code.

1.5 Reset Timeout

The XRSuper6/XR20/XR40 has a feature that requires you to enter the Programmer within 30 minutes of

resetting the panel. After 30 minutes, if you attempt to program by entering the 6653 (PROG) code,

the keypad displays: RESET PANEL. You must reset the panel and enter the program code within the

next 30 minutes.

If you are already in the Programmer and do not press any keys on the programming keypad for 30

minutes, the panel terminates programming. All data entered up to that point is saved in the panel's

memory.

Using the STOP function disarms all areas: To exit the panel's Programmer you must use the Stop

function. The STOP option is the second to the last option in programming. The Stop function disarms

all areas and clears the panel's Status List.

The programming session is then terminated and the keypad returns to the Status List.

INTRODUCTION

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 37 38

Commenti su questo manuale

Nessun commento

Digital Monitoring Products XR20 Guida di Installazione Pagina 8

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Digital Monitoring Products XR20