Digital Monitoring Products XR20 Guida di Installazione Scaricare il pdf (Pagina 33)

XRSuper6/XR20/XR40 Programming Guide

2500 N. Partnership Boulevard Springfield, MO 65803 www.dmpnet.com Digital Monitoring Products

10.1 STOP

At the STOP prompt, pressing any Select key allows you to exit the programmer

function of the XRSuper6/XR20/XR40 panel. When selected, the panel performs an

internal reset and exits the programmer. The Stop function causes the following

conditions to occur:

• The system is DISARMED

• The panel's Status List is CLEARED

During the Stop function, all keypad displays are momentarily blank for two seconds.

Afterwards, the programming function is terminated and the keypads return to the

Status List display.

11.1 SET LOCKOUT CODE

Pressing COMMAND at the Stop prompt displays SET LOCKOUT CODE. This feature

allows you to program a special code that will then be required to gain access to the

panel's internal Programmer through the keypad.

Changing the Lockout Code

You can change this code at any time to any combination of numbers from 1 to 5

digits long (1 to 65535). Leading zeros must not be used for the lockout code.

1. Press a Select key. The display changes to ENTER CODE: -.

2. Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press

COMMAND.

3. Enter the new Lockout Code again. Press COMMAND. The keypad display

changes to CODE CHANGED.

Once you have changed the code, it is important that you write it down somewhere

and store it in a safe place. Lost lockout codes require the panel to be sent back

into DMP for repair. You may cancel a Lockout Code by entering 00000 at the Set

Lockout Code command.

Lockout Code restriction

Do not set a Lockout Code higher than 65535.

STOP

SET LOCKOUT CODE

STOP

1 2 ... 28 29 30 31 32 33 34 35 36 37 38

Nessun commento

Digital Monitoring Products XR20 Guida di Installazione Pagina 33