Digital Monitoring Products XTL Series Guida di Installazione Scaricare il pdf (Pagina 18)

XTL/XTLC Programming Guide Digital Monitoring Products

DEVICE SETUP

Device Setup

5.1 Device Setup

This section allows you to dene the panel wireless keypad conguration. You can install

and address up to four wireless keypads.

5.2 Device Number

Enter the device number of the wireless keypad you are programming. The valid range is

2-5.

Note: Address one is reserved for the XTL/XTLC programming keypad attached during

programming. After you program each option for the rst keypad, repeat these

programming steps for each additional keypad.

5.3 Device Name

This section allows you to dene a 16 character alphanumeric name for the device

number. If no name is entered, *UNUSED* is displayed.

To remove a keypad from the system, delete the device name by pressing any Select key,

then press the COMMAND key. The device name is now displayed as * UNUSED *.

5.4 Wireless

Select YES to use a wireless keypad. Default is YES.

5.5 Serial Number

Enter the eight-digit serial number found on the wireless keypad.

5.6 Supervision Time

Press any top row key to select the supervision time required for the device. Press

COMMAND to accept the default time. Default is 240 minutes.

Press the Select key under the required number of minutes. The device must check in at

least once during this time or a missing condition is indicated for that device. Zero (0)

indicates an unsupervised wireless keypad.

Note: When the panel is reset, panel is powered down and powered up, or programming

is complete, the supervision timer restarts for all wireless keypads.

DEVICE SETUP

DEVICE NO:-

* UNUSED *

WIRELESS? NO YES

SERIAL#: XXXXXXXX

SUPRVSN TIME: 240

SELECT MINUTES:

0 60 240

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 48 49

Nessun commento

Digital Monitoring Products XTL Series Guida di Installazione Pagina 18