Digital Monitoring Products XTL Series Guida di Installazione Scaricare il pdf (Pagina 46)

XTL/XTLC Programming Guide Digital Monitoring Products

16.10 Common Keypad Messages

Message Meaning Possible Solutions

INVALID CODE

The user code you have entered is not

recognized by the system.

Check the user code and try again.

CLOSING TIME The schedule has expired but the system

has not been armed.

Users still on the premise should arm the system or

extend the schedule to a later time.

KEYPAD NAME - NOPWR

Wireless keypad is not getting proper

power.

Check that AC/DC transformer is plugged in

correctly.

AC TROUBLE The system is not getting proper power. Check that the AC connections are good.

BATTERY TROUBLE The battery is either low or missing.

Check that the battery connections are good and

the battery is still good.

SYSTEM TROUBLE or

SERVICE REQUIRED

There is a problem with one or more

components in the system.

Press the reset button for 1-2 seconds.

SYSTEM BUSY

The system is performing another task

with a higher priority.

Wait a few moments for the system to complete the

task. If the message displays for a long period of

time, the processor could be locked up.

TRANSMIT FAIL

The panel has attempted to communicate

with the central station 10 times and has

not succeeded.

Verify your communication type, account number,

and IP address.

ENTER CODE (When

entering Programming)

A lockout code has been programmed for

the panel.

Enter the lockout code.

16.11 Z-WaveCerticationInformation

The 738Z is a security enabled Z-Wave product and is designed to be used as a primary controller.

The XFER feature allows an existing 3rd party network to be transferred into the 738Z. To add the 738Z to another 3rd

party network, please contact technical support. This function is available with Remote Link.

The 738Z can support Z-Wave products from different vendors and product categories. It is recommended to use devices

listed on the buy.dmp.com site for best performance.

Z-Wave terminology:

• Inclusion is the process of adding a device to the Z-Wave network. The new device is ‘included’ into the

Z-Wave network. See “Adding 6-Wave Devices” in section 7 of Z-Wave Setup in this programming guide.

• Exclusion is the process of removing a device from the Z-Wave network. The new device is ‘excluded’ from

the Z-Wave network. See “Remove” in section 6 of Z-Wave Setup in this programming guide.

• Replication is the process of copying network information to another device (typically a Z-Wave controller)

in the Z-Wave network. See “Transfer Control” in Z-Wave Setup in this programming guide.

1 2 ... 41 42 43 44 45 46 47 48 49

Commenti su questo manuale

Nessun commento

Digital Monitoring Products XTL Series Guida di Installazione Pagina 46

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Digital Monitoring Products XTL Series