Digital Monitoring Products XTL Series Guida di Installazione Scaricare il pdf (Pagina 28)

XTL/XTLC Programming Guide Digital Monitoring Products

OUTPUT INFORMATION

Output Information

11.1 Output Information

This section allows you to program and name wireless outputs into the panel.

11.2 Output Number

Enter an output number. Select from the following output numbers:

• 31 to 34 —

Slow response

time

wireless outputs (activate within 15 seconds)

• 41 to 44 — Fast response time* wireless outputs (activate within 1 second)

Note: Addresses 31 to 34 and 41 to 44 are available for wireless outputs, wireless zones,

or wireless key fob zones and can only be assigned to one device.

* The response time of a wireless output is the time it takes for a wireless output to

activate once the panel event occurs. You determine whether a wireless output is a slow

or fast response based on the output number assigned. A slow response output number

extends battery life, but response time may be up to 15 seconds. A fast response output

number responds within 1 second, but reduces battery life. Refer to the specic wireless

output installation guide to determine battery life.

11.3 Output Name

This section allows you to dene a 16 character alphanumeric name for any wireless

output.

An output that is not part of the system must be marked *UNUSED*. To mark an output

unused, de lete the old name by pressing any Select key, then press the COMMAND key.

The pro grammer auto matically pro grams the name as * UNUSED *.

11.4 Serial Number

Enter the eight-digit serial number found on the wireless device.

This message displays when the serial number is already programmed for another output

or zone. The programmed output or zone number displays.

11.5 Supervision Time

Press any top row key to select the supervision time required for the wireless output.

Press COMMAND to accept the default time. Default is 240 minutes.

Select the required number of minutes. The transmitter must check in at least

once during this time or a missing condition is indicated for that zone. 1100 Series

transmitters automatically check in based on the supervision time selected for the

wireless zone, no additional programming is needed. Zero (0) indicates an unsupervised

transmitter.

The 3 minute supervision time is only available if using an 1135 Wireless Siren.

Note: When the panel is reset, a receiver is installed or powered down and powered up,

or programming is complete, the supervision timer restarts for all wireless outputs.

11.6 Trip with Panel Bell Option

This option displays when the wireless device is an 1135 wireless siren. Select YES to

have the 1135 wireless siren follow the panel bell output. Default is YES.

OUTPUT INFO

OUTPUT NO: -

* UNUSED *

SERIAL#: -

ALREADY USED: ZXX

SUPRVSN TIME: 240

0 3 60 240

TRIP WITH PANEL

BELL NO YES

INT PERIM

AREA NO: -

INT BDRM PERIM

* UNUSED *

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 48 49

Commenti su questo manuale

Nessun commento

Digital Monitoring Products XTL Series Guida di Installazione Pagina 28

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Digital Monitoring Products XTL Series