Digital Monitoring Products XTL Series Guida di Installazione Scaricare il pdf (Pagina 39)

Digital Monitoring Products XTL/XTLC Programming Guide

Stop

14.1 Stop

At the STOP option, pressing any Select key allows you to exit the programmer function

of the XTL/XTLC panel. When selected, the panel performs an internal reset and exits

the programmer. The Stop function causes the following conditions to occur:

• All 1100 Series DMP Wireless transmitters are reset to NORMAL

• The panel’s Status List is CLEARED

During the Stop function, all keypad displays are momentarily disabled for two seconds.

Afterwards, the programming function is terminated and the keypads return to the

Status List display.

SET LOCKOUT CODE

Set Lockout Code

15.1 Set Lockout Code

Pressing COMMAND at the Stop option displays SET LOCKOUT CODE. This feature allows

you to program a special code that will then be required to gain access to the panel’s

internal Programmer through the keypad.

Changing the Lockout Code

You can change this code at any time to any combination of numbers from 1 to 5 digits

long (1 to 65535). Do not use leading zeros for the lockout code.

1. Press any Select key. The display changes to ENTER CODE: -.

2. Enter a 1- to 5-digit code (do not enter a number higher than 65535). Press

COMMAND.

3. Enter the new Lockout Code again. Press COMMAND. The keypad display changes to

CODE CHANGED.

Once you have changed the code, it is important that you write it down and store it in a

safe place. Lost lockout codes require the panel to be sent back into DMP for repair. You

may cancel a Lockout Code by entering 00000 at the Set Lockout Code command option.

Lockout Code restriction

Do not set a Lockout Code higher than 65535.

STOP

SET LOCKOUT CODE

STOP

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 48 49

Nessun commento

Digital Monitoring Products XTL Series Guida di Installazione Pagina 39